WD-200B

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I clean my AiRScouter?

  • Cleaning the mirror unit
    Use a cotton swab moistened with ethanol to wipe off any dirt and dust on the mirror and lens cover.
      
      Mirror unit
    • The mirror unit consists of an optional mirror (with reflective and non-reflective sides) and a lens cover.
      Lens cover
      Optional Half Mirror (reflective side)
      Optional Half Mirror (reflective side)
      Optional Half Mirror (non-reflective side)
      Optional Half Mirror (non-reflective side)

    • Always wipe the reflective side gently. If you rub it too hard, it may peel off.

  • Cleaning the Head Band
    If the pads attached to the Head Band are dirty, wipe them using a dry cloth.

    If the dirt is difficult to remove, clean the pads using ethanol.
     

  • Cleaning the Control Box
    Wipe dust and dirt off the Control Box using a soft, dry cloth.

    If the dirt is difficult to remove, wipe the Control Box using a well-wrung damp cloth.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

WD-200B

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.