Reset the network settings.
You can restore any settings you changed via Wi-Fi® connection (WiFi AP Setting and Password Setup) to the factory settings.
Follow the steps below to reset the network settings.
-
Confirm that the scanner is turned on.
-
Set the Wi-Fi® switch to ON.
![Wi-Fi Switch Wi-Fi Switch](/g/b/img/faqend/faq00000105_028/us/en/1009962/Wi-FiSwitch.gif)
Wait about 40 seconds until the Wi-Fi® indicator turns from red to blue.
When your scanner makes a connection to your access point the Wi-Fi® indicator starts blinking blue.
-
Press and hold the scanner's reset button (1) using a pointed object, such as a needle or a fine-point pen for 10 seconds.
![ResetNetwork ResetNetwork](/g/b/img/faqend/faq00000105_028/us/en/1009967/ResetNetwork.gif)
-
Release the reset button. The Wi-Fi® indicator will turn red and the Wi-Fi® network settings will be restored to the factory settings.
When you press the reset button, the settings controlled by the buttons on the control panel will not be restored to the factory settings and the scanned images on the SD card will not be deleted.