FAQs & Troubleshooting
![]() |
Popular |
34 Results
- 1Combination of fabric, thread and needle
- 2Why does my thread keep jamming?
- 3When thread got tangled.
- 4Where do I put the oil in my machine?
- 5Place a spool of thread on a spool pin.
- 6Fabric and Thread
- 7It is difficult to pass the thread through the needle bar thread guide(hook).
- 8When I create an embroidery pattern design on PE-DESIGN(PE-DESIGN, PE-DESIGN Lite, or PED-Basic), what Design Page Size is my sewing machine?
- 9How do I correctly install a bobbin?
- 10Why does the lower thread keep breaking?
- 11How do I create a space between characters?
- 12How do I remove the presser foot holder?
- 13Why does the upper thread keep breaking?
- 14How do I thread my machine?
- 15Embroidery
- 16"The safety device has been activated. Is the thread tangled? Is the needle bent?" message appears on the LCD. What does it mean?
- 17How do I raise or lower the feed dogs?
- 18How do I sew a blind hem?
- 19Why is the outline sewing off the pattern?
- 20Why does the needle keep breaking?
- 21"When the speed controller is set to control the zigzag stitch width, the "Start/Stop" button does not operate." appears on the LCD.
- 22"Raise presser foot lever." message appearing on the LCD. What does it mean?
- 23Sometimes I insert a memory card or floppy disk, touch the appropriate icon, and the ULT screen blanks out, then turns back on.Sometimes the designs come up, but when I choose a design, the screen blanks out. Why is this?
- 24How do I wind the bobbin?
- 25"The pattern combination is too large for the extra large embroidery frame. If you plan to add more patterns, rotate the pattern combination." message appears on the LCD. What does it mean and how do I clear it?
- 26The thread tension is incorrect.
- 27"Lower the presser foot lever." appears on the LCD.
- 28"The foot controller cannot be used when the embroidery unit is attached. Remove the foot controller." message appears on the LCD. What does it mean?
- 29How do I sew buttonholes?
- 30"The "Start/Stop" button does not operate with the foot controller attached. Remove the foot controller." appears on the LCD.
- 31How do I sew an applique?
- 32How do I sew hook-and-loop fasteners(hook-and-loop tapes)?
- 33How do I sew such as vinyl, leather, quilting layers and velvet?
- 34Fabrics and stabilizer material for embroidery