FAQs & Troubleshooting

Close

Innov-is NV800E

FAQs & Troubleshooting

FAQs & Troubleshooting

Innov-is NV800E

Not your product?

Date: 12/11/2015 ID: faqh00000095_010

How do I clean the race?

If dust or bits of dirt collect in the race or bobbin case, the machine will not run well, and the bobbin thread detection function may not operate. Keep the machine clean for best results.
 

Unplug the power cord before cleaning the machine, otherwise injuries or an electric shock may occur.

 

 

  1. Press the image (Needle position button) to raise the needle.

     

  2. Turn off the machine.

     

  3. Unplug the power cord from the power supply jack on the right side of the machine.

     

  4. Remove the needle.
    Refer to How do I change the needle?

     

  5. Remove the presser foot.
    Refer to How do I remove or attach the presser foot?

     

  6. Remove the embroidery unit.

     

    image (1) Release button

     

  7. Remove the needle plate cover.
    Grasp both sides of the needle plate cover, and then slide it toward you.

     

    image (1) Needle plate cover

     

    If there is a screw in the needle plate cover, remove it using  the L-shaped (or disc-shaped) screwdriver before removing the needle plate cover.
    image
  8. Grasp the bobbin case, and then pull it out.
    image
    (1) Bobbin case
     

     

     

  9. Use the cleaning brush or a vacuum cleaner to remove any lint and dust from the race and bobbin thread sensor and its surrounding area.
    image (1) Cleaning brush

    (2) Race

    (3) Bobbin thread sensor

     

    Do not apply oil to the bobbin case.

     
  10. Insert the bobbin case so that the image mark on the bobbin case aligns with the image mark on the machine.

    image

    image

    (1) image mark

    (2) image mark

    (3) Bobbin case

    Align the image and image marks.
    image  

     

    Make sure that the indicated points are aligned before installing the bobbin case.

     

  11. Insert the tabs on the needle plate cover into the needle plate, and then slide the cover back on.
    image (1) Needle plate cover

     

    Tighten the screw in the needle plate cover firmly using the L-shaped (or disc-shaped) screwdriver if the screw was removed in step 7.
    image
    • Never use a bobbin case that is scratched, otherwise the upper thread may become tangled, the needle may break or sewing performance may suffer. For a new bobbin case, contact your nearest Brother authorized service center.
    • Be sure that the bobbin case is correctly installed. Otherwise, the needle may break.

  12. Install the embroidery unit back in its original position.

     

  13. Install the embroidery foot and the needle.

 

Related FAQs

Related Models

Innov-is NV800E, Innov-is NV880E

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.