MFC-9010CN
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/mfc9010cn_us.jpg)
MFC-9010CN
Date: 04/25/2013 ID: faq00000231_027
Printouts have wrinkles.
![Wrinkle](/g/b/img/faqend/faq00000231_027/us/en/20489/wrinkle_s.gif)
Please check the following points:
Step 1:
- Check that you use the paper that meets our specification.
Please refer to "What is the recommended paper?".
- Check that the drum units and toner cartridges are installed properly.
Please refer to the instructions, "How do I replace a drum unit?" and "How do I replace the toner cartridge?".
If you still have a print quality problem, please go to the Step 2.
Step 2:
- Make sure that the fuser cover (1) inside the back cover is closed properly.
- Make sure that the back cover is closed properly.
When using a straight paper path from the manual feed slot through to the back of the machine to print on thick paper, labels, envelopes or paper that is smaller than 4.1×5.8in. (105×148mm), keep the back cover open.
- Make sure that two gray levers inside the back cover, one on the left-hand side and one on the right-hand side, are pulled down.
- Make sure that the media type settings in the printer driver and in the machine's Paper Type menu matches the type of paper you are using.
MFC-9010CN, MFC-9120CN, MFC-9320CW
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.