ADS-2700W
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/ads2700w_us_eu_as.jpg)
ADS-2700W
Date: 02/15/2018 ID: faq00002892_500
Replace the Pick Up Roller
Your machine is equipped with a scan counter that automatically counts how many times the machine has scanned. After approximately 100,000 scans, you may have to replace the Pick Up Roller.
- Remove the ADF (1) .
- Press the release tab to open the Front Cover (1).
- While pushing the right side of the Pick Up Roller Cover (1) from the front of the machine, pull the cover down.
- Slide the upper Pick Up Roller (1) to the right, and then pull it out to remove it. Remove the lower Pick Up Roller (2) in the same way.
- Fit the new lower Pick Up Roller into the opening, and then slide it to the left onto the shaft.
- Fit the new upper Pick Up Roller into the opening, and then slide it to the left onto the shaft.
- Close the Pick Up Roller Cover.
- Close the Front Cover and attach the ADF.
- Reset the Pick Up Roller Counter. See Related Information:Reset the Usage Counters
- NOTE
- Confirm the following:
- The Roller Count value is 0.
- The touchscreen or LED indications do not display a replace Pick Up Roller message.
Related FAQs
ADS-2200, ADS-2700W
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.