CP2160R
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_cp2160reus.jpg)
CP2160R
Date: 11/10/2020 ID: faqh00000402_003
"E7" message appears on the LCD.
Cause
This message is displayed when an erroneous operation is performed as follows.
- The foot controller is pressed while the twin needle mode is active, and a stitch pattern that cannot be sewn with the twin needle is selected.
- The Reverse/Reinforcement stitch button is pressed while the twin needle mode is active, and a stitch pattern that cannot be sewn with the twin needle is selected.
(1) Needle mode indicator
or
shows that the twin needle mode is selected.
Solution
-
When you want to sew a pattern you selected :
Switch to the single needle mode, and replace the twin needle with a single needle before continuing the operation.
To change the needle mode, follow the steps below.
-
Turn off the machine.
-
Holding down
(Plus key of the stitch selection keys (for digit in the ones place)), turn on the machine.
-
After the machine has turned on, release the key.
The needle mode changes to the single needle mode.(1) Needle mode indicator
or
shows that the single needle mode is selected.
-
Turn off the machine.
-
When you want to sew with the twin needle :
Select a pattern that can be sewn with the twin needle.
Refer to "Stitch Chart" to learn stitches that can be sewn with a twin needle.
CE1150, CP2160F, CP2160L, CP2160M, CP2160P, CP2160R, CP2160W, CP60X, CP80X, CS5055
If you need further assistance, please contact Brother customer service:
Content Feedback
Please note this form is used for feedback only.