Innov-is 500D
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_inov500deus.jpg)
Innov-is 500D
Date: 05/26/2016 ID: faqh00000459_000
When should I use the extra spool pin?
When using spools with a size that cannot be loaded into the thread cassette, use the extra spool pin.
When threading the upper thread, carefully follow the instructions.
If the upper threading is not correct, the thread may become tangled or the needle may bend or break.
-
Place the spool of thread onto the extra spool pin.
Extra spool pin
Spool
-
Slide the spool cap for the size of the spool onto the spool pin.
Spool cap
-
Insert the tabs on the extra spool pin into the holes on the top of the thread cassette.
-
Thread the thread cassette with the thread from the spool on the extra spool pin.
-
Check that the thread cassette indicator is lit up in green, and insert the thread cassette (with the extra spool pin attached) into the thread cassette compartment.
Use both hands to press down on both sides of the extra spool pin.
Thread cassette indicator
- At the same time that the thread cassette is inserted, the needle is threaded.
- The extra spool pin is now installed.
CS-80, CS-8060, CS-8150, HE-120, Innov-is 500D, SE-270D
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.