AIRFLOW 3000
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_airflow3000eus.jpg)
AIRFLOW 3000
Date: 10/28/2022 ID: faqh00000526_001
To secure chains
There are two methods available to secure the chain.
Method 1
Secure the chains of the beginning and the end of a stitch with your machine.
At the beginning of a stitch
-
Sew a few stitches, after chaining-off for 5 cm (2 inches).
-
Stop the machine and raise the presser foot.
-
Put the chains under the presser foot, and serge over it pulling toward you.
-
After sewing a few stitches, cut off the extra chain with the upper knife as illustrated.
At the end of a stitch
-
At the end of the seam, sew one stitch out of the fabric before stopping the machine.
-
Raise the presser foot and the needles, then reverse the fabric.
-
Lower the needles and the presser foot at the same position.
-
Serge over the seam, taking care not to cut the serged seam with the upper knife.
-
After sewing a few stitches, serge off the fabric as illustrated.
- Cut the chain with scissors.
Method 2
With this method, the chains at the beginning and the end of a stitch can be secured in the same manner.
-
Tie the thread unpicked from chains.
-
Insert the chains into the end of the seam, using a hand sewing needle with large eye.
-
Fix the chains with a drop of fabric glue, and cut the extra stitches after dryin.
3234DT, 4234DT, 5234PRW, AIR 1800, AIRFLOW 3000, PS5234, PS5234
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.