Innov-is NQ3550W
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_inovnq3550weus.jpg)
Innov-is NQ3550W
Date: 02/14/2019 ID: faqh00101390_000
The embroidery design data cannot be transferred from PE-DESIGN 11 to the embroidery machine via the wireless network.
Check the following points or solutions.
1. Home network (Wireless LAN access point)
-
Make sure that the home network (wireless LAN access point) has been turned on.
-
Move the machine or computer installed with PE-DESIGN 11 so that no objects block the signals between them, or move them closer to the wireless LAN access point.
-
If the wireless LAN access point is filtering, check the settings.
For details, refer to the manual for your wireless LAN access point.
2. Embroidery machine
-
Data transfer function via the wireless network is available only when embroidering with our wireless LAN-compatible embroidery machines.
Be sure that the embroidery machine supports a wireless network connection.
-
Be sure that the embroidery machine connects to the same home network as the computer that PE-DESIGN 11 is installed.
If the computer and the embroidery machine are connected to different home network, embroidery patterns cannot be transferred or imported.
-
Be sure that the embroidery machine is turned on.
-
Check the wireless signal strength icon indicated in the embroidery machine's display.
If the icon is OFF, the network setting on the machine may be incorrect. Check the machine settings for the wireless connection.
If the signal strength is low, move your machine and WLAN access point/router closely, and try it again.
3. PE-DESIGN 11
- Be sure that the desired embroidery machine is registered with PE-DESIGN 11.
Related FAQs
Innov-is NQ1700E, Innov-is NQ3550W, Innov-is NQ3700D, Innov-is NS1250E, Innov-is NS1850D, Innov-is NS2850D, Innov-is XE1, Innov-is XE2, Innov-is XJ1, Innov-is XJ2, Innov-is XP1, Innov-is XP2, Innov-is XP3, LB5500, PE545, PE570, PE900, PE-DESIGN 11, SE2000, SE700, SE725
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.