PT-1910
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/1900eus_same.jpg)
PT-1910
Date: 05/29/2020 ID: faqp00000246_002
What does the error message "CHR SIZE AUTO?" on the display mean?
This message appears when the selected character size is too large for the width of the tape cassette installed.
You have the following options:
- Press the [Print] or [Return] key to allow the P-touch machine to automatically select the maximum character size that fits the tape width.
- Press the [BS] key to clear the message, and then install a wider tape cassette.
-
Press the [BS] key to clear the message, and then select a smaller character size by following these steps:
- While holding the [Code] key, press the [Size] key. The display will show the current character size.
-
Keep the [Code] key held, and press the [Size] key until the desired size is displayed.
If you select "AUTO", the P-touch machine will automatically adjust the character size to the largest possible size. - Release the [Code] key to apply the setting.
If you have the correct size tape installed and still get the error message, remove the cassette from the machine and reinstall it. Also, check that the tape cassette is seated firmly in the compartment.
The following table shows the maximum character size that can be used with each tape width.
Tape Width | Maximum Character Size |
---|---|
1/4" (6 mm) | 12 points |
3/8" (9 mm) | 18 points |
1/2" (12 mm) | 24 points |
3/4" (18 mm) | 42 points |
PT-1900, PT-1910
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.