TJ-4010TN
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/lptj4010tneus.jpg)
TJ-4010TN
Date: 12/10/2021 ID: faqp00100468_002
How to set the Gap/Black Mark Sensor as Media Sensor and calibrate the Gap/Black Mark Sensor by directly operating the printer
Follow the instructions below:
- Turn off the printer.
- Press and hold the Pause button, and then turn on the printer.
-
For the Black Mark Sensor
Release the button when the LED is lit in green/amber (5 times) after the green LED blinks five times alternately.
For the Gap Sensor
Release the button when the LED is lit in red/amber (5 times) after the green/amber LED blinks five times alternately.
You can also calibrate by using the BPM (Brother Printer Management Tool).
TJ-4010TN, TJ-4020TN, TJ-4120TN
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.