CM650W
FAQs & Troubleshooting |
CM650W
Sort by
15 Results
1. 12/26/2018
If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
2. 07/10/2017
Mat and Material Combinations
3. 07/10/2017
Mat and Cutting Blade Combinations
4. 07/10/2017
The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
5. 07/10/2017
The mat is fed in at an angle and is not fed during cutting / drawing.
6. 07/10/2017
The mat or the material catches on a feed roller during cutting/drawing.
7. 07/10/2017
When the mat is inserted, the attached material peels off.
8. 07/10/2017
The material to be cut/drawn or original to be scanned cannot be attached to the mat.
9. 08/19/2015
There are deep cuts completely through the mat.
10. 07/31/2015
The mat cannot be fed.
11. 07/31/2015
The mat cannot be recognized.
12. 01/22/2014
The mat cannot be inserted.
13. 11/28/2013
The mat or the material catches on a feed roller when the mat is being inserted.
14. 11/28/2013
The mat cannot be fed out.
15. 11/28/2013
The mat is fed in at an angle.