FAQs & Troubleshooting
![]() |
Popular |
![](/g/b/img/product/hf_cm350eus.jpg)
CM350
325 Results
1.
Mat and Cutting Blade Combinations
2.
About Blade Extension, Cutting Pressure and Mat
3.
Mat and Material Combinations
4.
Downloading Optional Design Pattern Collection
5.
List of Error Messages for CanvasWorkspace (Exxxxx / Nxxxxx)
6.
List of Error Messages for CanvasWorkspace (Others)
7.
List of Error Messages for CanvasWorkspace (ErrSxx / NoteSxx)
8.
Adjusting the Blade Extension
9.
How to Install and Uninstall the Holder
10.
How to register Your Machine with CanvasWorkspace
11.
Can I create the cutting data for ScanNCut from vector graphics data?
12.
Cut a thin fabric for the quilt piece. (How to use the High Tack Adhesive Fabric Support Sheet.)
13.
The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
14.
Can I create the cutting data for ScanNCut from the image data?
15.
What should I do if the scanned and cut positions are misaligned?
16.
If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
17.
Support OS Information about ScanNCut Link Plug-in for Adobe® Illustrator®
18.
How do I Scan for Cutting (Direct Cut) ?
19.
The mat is fed in at an angle and is not fed during cutting / drawing.
20.
Instructions for sending patterns created in CanvasWorkspace to the cutting machine for cutting or drawing.
21.
Cut the fabric other than quilt pieces. (How to use the Iron-On Fabric Appliqué Contact Sheet.)
22.
List of Error Messages
23.
FC1 files on USB flash drives of optional patterns cannot be imported into CanvasWorkspace.
24.
How to create an account for CanvasWorkspace
25.
The Calligraphy Font in the USB Flash Drive is Not Displayed
26.
How can I transfer the created/edited data between CanvasWorkspace and my machine via a wireless network?
27.
When I created a cutting data scanning my illustration, some areas were not converted to the cutting lines.
28.
How To Change the Registered Machine Number That Imports The Optional Pattern Collection (Ex. Disney Pattern and Calligraphy Pattern/Font)
29.
How to connect my machine to a wireless network using the Setup Wizard
30.
What type of data can my ScanNCut machine be used?