Search

Site Map

Home > Print Labels > Select a Cut Option (PT-E310BT)

Select a Cut Option (PT-E310BT)

Related Models:PT‑E310BT
  1. Press image.
  2. Press image or image to display [Cut Option], and then press image or image to select the option you want.

    In the tables below, these visual patterns represent parts of your label, as illustrated in the Example column.

    image
    		 Print area
    image
    		 Margin
    image
    		 Laminate margin
    Setting
    Description
    Example
    Small Margin
    The tape automatically feeds 0.9" (23 mm) first, and then each label is printed, leaving a margin of 0.08" (2 mm) before and after the text.
    • When each label length is approximately 0.9" (23 mm) or more
      image
      1. Approximately 0.9" (23 mm)
      2. 0.08" (2 mm)
    • When each label length is approximately 0.9" (23 mm) or less
      image
      1. Approximately 0.9" (23 mm)
      2. 0.08" (2 mm)
    Chain
    • Select this setting when printing several labels with minimum margins.
    • A margin of 0.9" (23 mm) is printed first, and then each label is printed, leaving a margin of 0.08" (2 mm) before and after the text.
    • Feed the tape before using the Tape Cutter, otherwise part of the text may get cut off. Do not try to pull the tape as this may damage the Tape Cassette.
    image
    1. Approximately 0.9" (23 mm)
    2. 0.08" (2 mm)
    3. Tape Stop Position
    No Cut
    • Select this setting when printing multiple copies of a label or when using Heat Shrink Tube or any other tapes that cannot be cut using the Tape Cutter and instead must be cut with scissors.
    • Feed the tape before using the Tape Cutter, otherwise part of the text may get cut off. Do not try to pull the tape as this may damage the Tape Cassette.
    • When using any tapes that cannot be cut using the Tape Cutter, remove the Tape Cassette after printing, and use scissors to cut the tape.
    image
    1. Approximately 0.9" (23 mm)
    2. 0.08" (2 mm)
    3. Tape Stop Position
    Large Margin

    The total margin (laminate margin + label margin) is 0.98" (25 mm) on either side of the label.

    image
    1. Approximately 0.9" (23 mm)
    2. 0.08" (2 mm)
    Special Tape
    • Select this setting when using any special tape.
    • When using Fabric Iron-On Tapes or Heat Shrink Tube, set Special Tape for Cut Option before printing. After printing, remove the Tape Cassette from the Labeling System and use scissors to cut the tape.
    image
    1. Approximately 0.9" (23 mm)
    2. 0.08" (2 mm)
  3. Press OK.
    image
    • When you set the cut option to [No Cut] or [Chain], the cut position is set in the middle of printing area after the last label is printed. When [Start feeding?] appears on the LCD, press OK to feed the tape. Press Esc to return to the text entry screen.
    • When you set the cut option to [Large Margin], [Small Margin], or [Chain], the message [Cut tape or press Enter to continue.] appears after printing, and the Labeling System enters Cut Pause Mode.
Related Information
Did you find the information you needed?

find moreaccept