Search

Site Map

Home > Network > Network Features > Configure and Operate LDAP Search > Perform an LDAP Search Using Your Machine's Control Panel

Perform an LDAP Search Using Your Machine's Control Panel

Related Models:ADS‑1800W
After you configure LDAP settings, you can use the LDAP search feature to find email addresses to use for scanning to Email Server.
image
  • The LDAP feature supports LDAPv3.
  • You may need to use Kerberos Authentication or Simple Authentication to connect to your LDAP server, depending on the security policy set by your network administrator.
  • You must configure the SNTP protocol (network time server), or you must set the date, time and time zone correctly on the control panel for Kerberos authentication.
  1. Press image to search.
  2. Enter the initial characters for your search using the LCD.
  3. Press [OK].
    The LDAP search result will be shown on the LCD; the image icon appears before the email (local) address book search results.
    • If there is no match on the server or the email (local) address book, the LCD displays [Results cannot be found.] for about 60 seconds.
  4. Press image or image to display the name you want.
  5. Press the name and check the contact information is correct.
  6. Press [Apply].
  7. Load your document, press [OK], and then press [Start].
Related Information
Did you find the information you needed?

find moreaccept