Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
If your wireless access point/router supports WPS (Push Button Configuration), you can use WiFi Button/LED on your machine's control panel to configure your wireless network settings.
- Press WiFi Button/LED three times.The WiFi Button/LED starts blinking.
- Press the WPS button on your wireless access point/router.
If your wireless device is connected successfully, the Power LED and WiFi Button/LED are lit.
You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com.
(Windows) Or, use the Brother installation disc to set up your machine (not available in all countries).
Did you find the information you needed?