Search

Site Map

Home > Paper Handling > Load Paper > Load Paper in the Paper Tray > Load Cut-Sheet Paper or Photo 2L Paper in the Paper Tray

Load Cut-Sheet Paper or Photo 2L Paper in the Paper Tray

  • If the [Check Paper] setting is set to [On] and you pull the paper tray out of the machine, a message appears on the LCD, allowing you to change the paper size and paper type.
  • Load only one size and type of paper in the paper tray at a time.
  • When you load a different paper size in the tray, you must change the Paper Size setting in the machine or the paper size setting on your computer.

    Doing this enables the machine to automatically feed paper from the appropriate tray if Auto Tray Select has been set in the printer driver (Windows) or on the machine. (DCP-T820DW/MFC-T920DW)

  1. If the paper support flap (1) is open, close it, and then close the paper support (2).
    image
  2. Pull the paper tray completely out of the machine.
    image
  3. Lift the output paper tray cover (1).
    image
  4. Gently press and slide the paper width guides (1) and then the paper length guide (2) to fit the paper size.
    image
  5. Fan the stack of paper well to avoid paper jams and misfeeds.
    image
    image
    Always make sure the paper is not curled or wrinkled.
  6. Gently load paper in the paper tray with the printing surface face down.
    image

    Make sure the paper is flat in the tray and the paper length guide (1) touches the edges of the paper.

    image
    IMPORTANT
    • Be careful not to push the paper in too far; it may lift at the back of the tray and cause paper feed problems.
    • Loading more than 20 sheets of Photo 2L (13 x 18 cm) paper may cause paper jams.
    image

    To add paper before the tray is empty, remove the paper from the tray and combine it with the paper you are adding. Always fan the stack of paper well to prevent the machine from feeding multiple pages.

  7. Gently adjust the paper width guides (1) to fit the paper.
    Make sure the paper width guides touch the edges of the paper.
    image
  8. Close the output paper tray cover.
    image
  9. Slowly push the paper tray completely into the machine.
    image
  10. Pull out the paper support (1) until it locks into place, and then unfold the paper support flap (2).
    image
Related Information
Did you find the information you needed?

find moreaccept