Search

Site Map

Home > Paper Handling > Load Paper > Load Paper in Paper Tray #1 / Paper Tray #2 > Load Legal Size Paper in the Paper Tray #1 / Paper Tray #2

Load Legal Size Paper in the Paper Tray #1 / Paper Tray #2

  • If the [Check Paper] setting is set to [On] and you pull the paper tray out of the machine, a message appears on the LCD, allowing you to change the paper size and paper type.
  • Load only one size and type of paper in the paper tray at a time.
  • When you load a different paper size in the tray, you must change the Paper Size setting in the machine or the paper size setting on your computer.

    Doing this enables the machine to automatically feed paper from the appropriate tray if Auto Tray Select has been set in the printer driver (Windows) or on the machine. (MFC-J4540DW)

  • You can use only plain paper in Tray #2. (MFC-J4540DW)

These instructions describe how to load paper in Tray #1.

  • (MFC-J4540DW) The steps for Tray #2 are very similar.
image

This operation is available only for some countries.

  1. If the paper support flap (1) is open, close it, and then close the paper support (2).
    image
  2. Pull the paper tray completely out of the machine.
    image
  3. Press the square paper tray expansion button (1) and slide out the paper tray until the square paper tray expansion button locks into the square LGL hole.
    image

    image

  4. Gently press and slide the paper width guides (1) and the paper length guide (2) to fit the paper size.
    image
  5. Fan the stack of paper well to avoid paper jams and misfeeds.
    image
    image
    Always make sure the paper is not curled or wrinkled.
  6. Gently load paper in the paper tray with the printing surface face down.
    image

    Make sure the paper is flat in the tray and the paper length guide (1) touches the edges of the paper.

    image
    IMPORTANT
    Be careful not to push the paper in too far; it may lift at the back of the tray and cause paper feed problems.
    image
    To add paper before the tray is empty, remove the paper from the tray and combine it with the paper you are adding. Always fan the stack of paper well to prevent the machine from feeding multiple pages.
  7. Gently adjust the paper width guides (1) to fit the paper.
    Make sure the paper guides touch the edges of the paper.
    image
  8. Slowly push the paper tray completely into the machine.
    image
  9. Pull out the paper support (1) until it locks into place, and then unfold the paper support flap (2).
    image
Related Information
Did you find the information you needed?

find moreaccept