Home > Paper Handling > Load Documents > Load Documents in the Automatic Document Feeder (ADF)
Load Documents in the Automatic Document Feeder (ADF)
Use the ADF when copying or scanning multi page, standard-sized documents.
The ADF can hold the following sheets and feed each sheet individually:
(DCP-L5510DN/MFC-L5710DN/MFC-L5710DW/MFC-L5715DW/MFC-L5717DW)
Up to 50 sheets
(DCP-L5660DN/MFC-L5915DW)
Up to 70 sheets
(MFC-L6810DW/MFC-L6915DW)
Up to 80 sheets
- Use standard 20 lb (80 g/m2) paper.
- Make sure documents with correction fluid or written in ink are completely dry.
- IMPORTANT
-
- DO NOT leave thick documents on the scanner glass. If you do this, the ADF may jam.
- DO NOT use paper that is curled, wrinkled, folded, ripped, stapled, paper-clipped, glued together, or taped.
- DO NOT use cardboard, newspaper, or fabric.
- To avoid damaging your machine while using the ADF, DO NOT pull on the document while it is feeding.
Supported Document Sizes
Length: | 5.8 to 14.0 in. (147.3 to 355.6 mm) |
Width: | 4.1 to 8.5 in. (105 to 215.9 mm) |
Weight: | 17 to 24 lb (64 to 90 g/m2) |
- Unfold the ADF document output support flap.
- Fan the pages well.
- Stagger the pages of your document and load it into the ADF face up and top edge first, as shown in the illustration.
- Adjust the paper guides to fit the width of your document.
Did you find the information you needed?