Remote Retrieval Commands

Home > Fax > Receive a Fax > Remote Fax Retrieval > Remote Retrieval Commands

Use the Remote Commands in this table to access fax commands and options when you are away from your machine. When you call the machine and enter your remote access code (three digits followed by *), the system will sound two short beeps and you must enter a Remote Command (column 1), followed by one of the options (column 2) for that command.

Remote command	Option	Description
95	Change the Fax Forwarding, or Fax Storage settings
	1 OFF	You can select Off after you retrieve or erase all your messages.
	2 Fax Forwarding	One long beep means the change is accepted. If you hear three short beeps, you cannot make a change because one of the settings may not be configured correctly (for example, a Fax Forwarding number has not been registered). You can register your Fax Forwarding number by entering 4. After you register the number, Fax Forwarding will work.
	4 Fax Forwarding number
	6 Fax Storage
96	Retrieve a fax
	2 Retrieve all faxes	Enter the fax number of a remote fax machine to receive stored fax messages.
	3 Erase faxes from memory	If you hear one long beep, fax messages have been erased from memory.
97	Check the receiving status
97	1 Fax	Check whether your machine has received any faxes. If yes, you will hear one long beep. If not, you will hear three short beeps.
98	Change the Receive Mode
	1 External TAD	One long beep means the change has been accepted.
	2 Fax/Tel
	3 Fax Only
90	Exit	Press 9 0 to stop remote retrieval. Wait for the long beep, then hang up.

Related Information

Remote Fax Retrieval

Did you find the information you needed?