Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
- NOTE
-
The wireless network connection can be used only when the optional Wireless Module is installed.
If your wireless access point/router supports WPS (PBC: Push Button Configuration), you can use WPS from your machine's control panel menu to configure your wireless network settings.
- Press
. 
If your machine displays the [All Settings] menu on the Home screen, skip the [Settings] menu. - When [Enable WLAN?] appears, press [Yes].This will start the wireless setup wizard. To cancel, press [No].
- When the touchscreen displays [Start WPS on your wireless access point/router, then press [OK].], press the WPS button on your wireless access point/router. Then press [OK] on your machine. Your machine will automatically detect your wireless access point/router and try to connect to your wireless network.
If your wireless device is connected successfully, the machine's LCD displays [Connected], and then press [OK]. Press 
.
. You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com.
Did you find the information you needed?