Home > Network > Network Features > Configure and Operate LDAP Search > Change LDAP Configuration Using Web Based Management
Change LDAP Configuration Using Web Based Management
Use Web Based Management to configure your LDAP settings in a web browser.
- Start your web browser.
- Type "https://machine's IP address" in your browser's address bar (where "machine's IP address" is the machine's IP address).
For example:
https://192.168.1.2
- If required, type the password in the Login field, and then click Login.
The default password to manage this machine’s settings is located on the back of the machine and marked "Pwd". - Go to the navigation menu, and then click .Start from
, if the navigation menu is not shown on the left side of the screen. - Select the LDAP checkbox, and then click Submit.
- Click Yes to restart your Brother machine and activate the configuration.
- On your computer, in Web Based Management, go to the navigation menu, and then click .
- LDAP Search
- LDAP Server Address
- Port (The default port number is 389.)
- Search Root
- Authentication
- Username
This selection will be available depending on the authentication method used.
- Password
This selection will be available depending on the authentication method used.
- If the LDAP server supports Kerberos authentication, we recommend selecting Kerberos for the Authentication settings. It provides strong authentication between the LDAP server and your machine.
- You must configure the SNTP protocol (network time server), or you must set the date, time and time zone correctly on the control panel for Kerberos authentication.
- Kerberos Server Address
This selection will be available depending on the authentication method used.
- Timeout for LDAP
- Attribute of Name (Search Key)
- Attribute of E-mail
- Attribute of Fax Number
- Optional Attribute ##
- When finished, click Submit. Make sure the Status field reads OK.
Did you find the information you needed?