Search

Enable Receive Notification for TX Verification Mail

  1. Press image[Settings]>[All Settings]>[Network]>[E-mail/IFAX]>[Setup Mail RX]>[Notification].
    image
    If your machine displays the [All Settings] menu on the Home screen, skip the [Settings] menu.
  2. Press one of the three possible settings:
    Option
    Description

    Receive Notification On

    When Receive Notification is On, a template is sent back to the sender to indicate successful reception and processing of the message.

    These templates depend on the operation requested by the sender.

    Example:

    SUCCESS : Received From <Mail Address>

    Receive Notification MDN

    When Receive Notification is MDN, a report to indicate successful reception and processing is sent back to the sender if the originating station sent a request confirmation to the MDN (Message Disposition Notification) field.

    Receive Notification Off

    When Receive Notification is Off, all forms of receive notification are disabled and no message is sent back to the sender regardless of the request.

    image
    • To send TX Verification Mail, the Sender must configure these settings:

      • Switch [Notification] in [Setup Mail TX] to [On].

      • Switch [Header] in [Setup Mail RX] to [All] or [Subject+From+To].

    • To receive TX Verification Mail, the Receiver must configure these settings:

      • Switch [Notification] in [Setup Mail RX] to [On].

  3. Press image.
Did you find the information you needed?