Search

Site Map

Home > Paper Handling > Load Paper > Load Paper in the Paper Tray > Load Photo Paper in the Paper Tray

Load Photo Paper in the Paper Tray

  • If the [Check Paper] setting is set to [On] and you pull the paper tray out of the machine, a message appears on the LCD, allowing you to change the paper size and paper type.
  • Load only one size and type of paper in the paper tray at a time.
  • When you load a different paper size in the tray, you must change the Paper Size setting in the machine or the paper size setting on your computer.
  1. If the paper support flap (1) is open, close it, and then close the paper support (2).
    image
  2. Pull the paper tray completely out of the machine.
    image
  3. Lift the output paper tray cover (1).
    image
  4. Gently press and slide the paper width guides (1) to fit the paper size, and then lift the stopper (2).
    image
  5. Close the output paper tray cover.
    image
  6. Load up to 20 sheets of photo paper with the printing surface face down.
    Loading more than 20 sheets of photo paper may cause paper jams.
    image
  7. Lift the output paper tray cover.
  8. Gently adjust the paper width guides (1) to fit the paper.
    Make sure the paper width guides touch the edges of the paper and the paper is flat in the tray.
    image
  9. Close the output paper tray cover.
  10. Slowly push the paper tray completely into the machine.
    image
  11. Pull out the paper support (1) until it locks into place, and then unfold the paper support flap (2).
    image
Related Information
Did you find the information you needed?

find moreaccept