Home > Paper Handling > Load Documents > Load Documents in the Automatic Document Feeder (ADF)
Load Documents in the Automatic Document Feeder (ADF)
Use the ADF when copying or scanning multiple-page, standard-sized documents.
- The ADF can hold up to 100 sheets and feed each sheet individually.
- Use standard 80 g/m2 paper.
- Make sure documents with correction fluid or written in ink are completely dry.
- IMPORTANT
-
- DO NOT leave thick documents on the scanner glass. If you do this, the ADF may jam.
- DO NOT use paper that is curled, wrinkled, folded, ripped, stapled, paper-clipped, pasted, or taped.
- DO NOT use cardboard, newspaper, or fabric.
- To avoid damaging your machine while using the ADF, DO NOT pull on the document while it is feeding.
Document Sizes Supported
| Length: | 147.3 to 355.6 mm |
| Width: | 105 to 215.9 mm |
| Weight: | 45 to 120 g/m2 |
- Unfold the ADF document output support flap.
- Fan the pages well.
- Stagger the pages of your document and load it face up and top edge first, into the ADF as shown in the illustration.
- Adjust the paper guides to fit the width of your document.
Did you find the information you needed?