Search

Change the Remote Codes

Related Models:MFC‑T910DW

The preset Remote Activation Code is *51. The preset Remote Deactivation Code is #51. If you are always disconnected when accessing your External TAD remotely, try changing the three-digit remote codes using the numbers 0-9, *, #.

  1. Press Settings.
  2. Press image or image to select the following:
    1. Select [Fax]. Press OK.
    2. Select [Setup Receive]. Press OK.
    3. Select [Remote Codes]. Press OK.
    4. Select [Remote Codes] again. Press OK.
    5. Select [On]. Press OK.
  3. Do one of the following:
    • To change the Remote Activation Code, press image or image to select [Act.Code] and then press OK. Enter the new code. Press OK.
    • To change the Remote Deactivation Code, press image or image to select [Deact.Code] and then press OK. Enter the new code. Press OK.
  4. Press Stop/Exit.
Was this page helpful?

Yes

No