Home > Network > Additional Methods of Configuring Your Brother Machine for a Wireless Network > Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
If your wireless access point/router supports WPS (Push Button Configuration), you can use WPS from your machine's control panel menu to configure your wireless network settings.
DCP-T510W/DCP-T710W/MFC-T810W
- Press Menu.
- Press or to select the following:
- Select [Network]. Press OK.
- Select [WLAN]. Press OK.
- Select [WPS]. Press OK.
- When [WLAN Enable?] appears, press to select [Yes].This will start the wireless setup wizard. To cancel, press Stop/Exit.
- When the LCD instructs you to start WPS, press the WPS button on your wireless access point/router. Then press OK on your machine. Your machine automatically tries to connect to your wireless network.
You have completed the wireless network setup. To install the Full Driver & Software Package necessary for operating your machine, insert the Brother installation disc into your computer, or go to your model's Downloads page on the Brother Solutions Center at support.brother.com.
MFC-T910DW
- Press Settings.
- Press or to select the following:
- Select [Network]. Press OK.
- Select [WLAN]. Press OK.
- Select [WPS]. Press OK.
- When [Enable WLAN?] appears, press .The wireless setup wizard starts. To cancel, press .
- When the LCD instructs you to start WPS, press the WPS button on your wireless access point/router. Then press on your machine. Your machine automatically tries to connect to your wireless network.
You have completed the wireless network setup. To install the Full Driver & Software Package necessary for operating your machine, insert the Brother installation disc into your computer, or go to your model's Downloads page on the Brother Solutions Center at support.brother.com.