Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
If your wireless access point/router supports WPS (Push Button Configuration), you can use WPS from your machine's control panel menu to configure your wireless network settings.
DCP-T520W/DCP-T525W/DCP-T720DW/DCP-T725DW/DCP-T820DW/DCP-T825DW
- Press WiFi.
- Press
or 
to select [WPS/PushButton]. Press OK. - When the [WLAN Enable?] message appears, press to select [On]. This starts the wireless setup wizard. To cancel, press.
- When the LCD instructs you to start WPS, press the WPS button on your wireless access point/router. Then press. Your machine automatically tries to connect to your wireless network.
You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com.
(Windows) Or, use the Brother installation disc to set up your machine (not available in all countries).
MFC-T920DW/MFC-T925DW
- Press
. - Press or to select the [WPS/Push Button] option, and then press OK.
- When [Enable WLAN?] appears, press
. The wireless setup wizard starts. To cancel, press
. - When the LCD instructs you to start WPS, press the WPS button on your wireless access point/router. Then press on your machine. Your machine automatically tries to connect to your wireless network.
You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com.
(Windows) Or, use the Brother installation disc to set up your machine (not available in all countries).