Search

Site Map

Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)

Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)

Related Models:DCP‑L2620DW / DCP‑L2622DW / DCP‑L2627DW / DCP‑L2627DWXL / DCP‑L2627DWE / DCP‑L2660DW / DCP‑L2665DW / MFC‑L2800DW / MFC‑L2802DW / MFC‑L2827DWXL / MFC‑L2827DW / MFC‑L2835DW / MFC‑L2860DWE / MFC‑L2860DW / MFC‑L2862DW / MFC‑L2922DW / MFC‑L2960DW / MFC‑L2980DW

If your wireless access point/router supports WPS (PBC: Push Button Configuration), you can use WPS from your machine's control panel menu to configure your wireless network settings.

DCP-L2620DW/DCP-L2622DW/DCP-L2627DW/DCP-L2627DWXL/DCP-L2627DWE/MFC-L2800DW/MFC-L2802DW/MFC-L2827DWXL/MFC-L2827DW/MFC-L2835DW

  1. Press Menu.
  2. Press image or image to select the [Network] option, and then press OK.
  3. Press image or image to select the [WLAN(Wi-Fi)] option, and then press OK.
  4. Press image or image to select the [WPS/PushButton] option, and then press OK.
  5. When [WLAN Enable?] appears, select On.
    This will start the wireless setup wizard.
  6. When the LCD displays [Press Key on rtr], press the WPS button on your wireless access point/router. Then follow the LCD instructions on your machine. Your machine will automatically detect your wireless access point/router and try to connect to your wireless network.
If your wireless device is connected successfully, the machine's LCD displays [Connected].

You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com/downloads.

DCP-L2660DW/DCP-L2665DW/MFC-L2860DWE/MFC-L2860DW/MFC-L2862DW/MFC-L2922DW/MFC-L2960DW/MFC-L2980DW

  1. Press image[Settings]>[All Settings]>[Network]>[WLAN(Wi-Fi)]>[WPS/Push Button].
  2. When [Switch Network interface to wireless?] appears, press [Yes].
    This will start the wireless setup wizard. To cancel, press [No].
  3. When the touchscreen displays [Start WPS on your wireless access point/router, then press [OK].], press the WPS button on your wireless access point/router. Then press [OK] on your machine. Your machine will automatically detect your wireless access point/router and try to connect to your wireless network.
If your wireless device is connected successfully, the machine's LCD displays [Connected].

You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com/downloads.

Related Information
Did you find the information you needed?

find moreaccept