Search

Site Map

Home > Routine Maintenance > Replace Supplies

Replace Supplies

You must replace supplies when the machine indicates that the life of the supply is over.

Using non-Brother supplies may affect the print quality, hardware performance, machine reliability, and may void the machine's warranty. The toner cartridge and drum unit are two separate supplies. Make sure both are installed as an assembly. The model name of supplies may vary depending on the country.

IMPORTANT
  • To avoid print quality problems, DO NOT touch the shaded parts shown in the illustrations.

    Toner Cartridge

    Toner Cartridge

    Drum Unit

    Drum Unit
    image

    Belt Unit

    Belt Unit
    image

    Waste Toner Box

    Waste Toner Box
NOTE
  • Availability of toner cartridges differs from one country to another. Visit support.brother.com or contact your local Brother office for further details.
  • Be sure to seal the used supplies tightly in a bag so that toner powder does not spill out of the cartridge.
  • Discard used consumable items according to local regulations, keeping it separate from domestic waste. If you have questions, call your local waste disposal office. Be sure to reseal the consumable items tightly so that the material inside does not spill.
  • We recommend placing both the new and the used supplies on a piece of paper to prevent accidentally spilling or scattering the contents.
  • Using paper that is not a direct equivalent for a recommended print media may reduce the life of supplies and machine parts.
  • The projected life for each of the toner cartridges is based on ISO/IEC 19798. Frequency of replacement will vary depending on the print volume, percentage of coverage, types of media used, and powering on/off the machine.
  • Frequency of replacing supplies except toner cartridges will vary depending on the print volume, types of media used, and powering on/off the machine.
  • Handle the toner cartridge carefully. If toner scatters on your hands or clothes, immediately wipe or wash it off with cold water.
image

  • DO NOT touch the IC chip surfaces on the toner cartridge and the belt unit. Contamination and damage may interfere with the detection of each unit.

Related Information
Did you find the information you needed?

find moreaccept