Search

Site Map

Home > Introduction to Your Brother Machine > Control Panel Overview

Control Panel Overview

HL-L2310D

image

  1. image Power On/Off Button

    • Turn on the machine by pressing image.

    • Turn off the machine by pressing and holding image.

  2. Toner LED
    The Toner LED indicates that the Toner is low.
  3. Drum LED
    The Drum LED indicates that the Drum Unit must be replaced soon.
  4. Paper LED
    The Paper LED indicates that there is an error relating to paper feeding.
  5. Ready LED
    The Ready LED blinks to indicate the machine's status.
  6. Go Button
    • Press Go to clear certain errors.
    • Press Go to print any data remaining in the machine's memory.
    • Press and hold Go for about two seconds to cancel a print job.

HL-L2350DW/HL-L2357DW/HL-L2370DN/HL-L2375DW

The control panel will vary depending on your model.

image

  1. LCD (Liquid Crystal Display)
    Displays messages to help you set up and use your machine.

    Wireless Models:

    A four-level indicator shows the wireless signal strength if you are using a wireless connection.

    image
  2. image Power On/Off Button

    • Turn on the machine by pressing image.

    • Turn off the machine by pressing and holding image. The LCD displays [Shutting Down] for a few seconds before going off.

  3. Network Buttons

    • Wired Models:

      Network

      Press Network to set up wired network settings.

    • Models with Wireless Function:

      WiFi

      Press the WiFi button and launch the wireless installer on your computer. Follow the on-screen instructions to set up a wireless connection between your machine and your network.

      When the WiFi light is on, your Brother machine is connected to a wireless access point. When the WiFi light blinks, the wireless connection is down, or your machine is in the process of connecting to a wireless access point.

  4. Menu Buttons
    OK

    Press to store your machine settings. After you change a setting, the machine returns to the previous menu level.

    Back
    • Press to go back one level in the menu.
    • Press to select the previous digit when setting numbers.
    image or image ( + or -)
    • Press to scroll through menus and options.
    • Press to enter a number or to increase or decrease the number. Press and hold down image or image to scroll faster. When you see the number you want, press OK.
  5. Go Button
    • Press to clear certain error messages. To clear all other errors, follow the control panel instructions.
    • Press to print any data remaining in the machine's memory.
    • Press to select the displayed option. After you change a setting, the machine returns to Ready mode.
    • Press and hold Go for about two seconds to cancel a print job.
Related Information
Did you find the information you needed?

find moreaccept