Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a Wireless Network When the SSID Is Not Broadcast
Configure Your Machine for a Wireless Network When the SSID Is Not Broadcast
Before configuring your machine, we recommend writing down your wireless network settings. You will need this information before you continue with the configuration.
- Check and write down the current wireless network settings.
Network Name (SSID) Authentication Method Encryption Mode Network Key Open System NONE - WEP Shared Key WEP WPA/WPA2-PSK AES TKIP WPA3-SAE AES For example:
Network Name (SSID) HELLO Authentication Method Encryption Mode Network Key WPA2-PSK AES 12345678 
If your router uses WEP encryption, enter the key used as the first WEP key. Your Brother machine supports the use of the first WEP key only. - Press
or 
to select the [Network] option, and then press OK. - Press or to select the [WLAN(Wi-Fi)] option, and then press OK.
- Press or to select the [Find Network] option, and then press OK.
- When [WLAN Enable?] appears, select On.This will start the wireless setup wizard.
- The machine will search for your network and display a list of available SSIDs. Press or to select the [<New SSID>] option, and then press OK.
- Enter the SSID name, and then press OK.
- Press or to select the Authentication Method you want, and then press OK.
- Do one of the following:
If you selected the [Open System] option, press
or to select the Encryption Type [None] or [WEP], and then press OK. If you selected the [WEP] option for Encryption Type, enter the WEP key, and then press OK.
- If you selected the [Shared Key] option, enter the WEP key, and then press OK.
If you selected the [WPA-Personal] option, press
or to select the Encryption Type [TKIP+AES] or [AES], and then press OK. Enter the WPA™ key, and then press OK.
If you selected the [WPA3-SAE] option, select the Encryption Type [AES], and then press OK.
Enter the WPA™ key, and then press OK.
Your Brother machine supports the use of the first WEP key only. - To apply the settings, select [Yes].
- The machine will attempt to connect to the wireless device you have selected.
You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com/downloads.