Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for an Enterprise Wireless Network
Configure Your Machine for an Enterprise Wireless Network
Before configuring your machine, we recommend writing down your wireless network settings. You will need this information before you continue with the configuration.
- Check and record the current wireless network settings.
Network Name (SSID) Authentication Method Encryption Mode User ID Password EAP-FAST/NONE AES TKIP EAP-FAST/MS-CHAPv2 AES TKIP EAP-FAST/GTC AES TKIP PEAP/MS-CHAPv2 AES TKIP PEAP/GTC AES TKIP EAP-TTLS/CHAP AES TKIP EAP-TTLS/MS-CHAP AES TKIP EAP-TTLS/MS-CHAPv2 AES TKIP EAP-TTLS/PAP AES TKIP EAP-TLS AES - TKIP - For example:
Network Name (SSID) HELLO Authentication Method Encryption Mode User ID Password EAP-FAST/MS-CHAPv2 AES Brother 12345678 
If you configure your machine using EAP-TLS authentication, you must install the client certificate issued by a CA before you start configuration. Contact your network administrator about the client certificate. If you have installed more than one certificate, we recommend writing down the certificate name you want to use.
If you verify your machine using the common name of the server certificate, we recommend writing down the common name before you start configuration. Contact your network administrator about the common name of the server certificate.
- Press
or 
to select the [Network] option, and then press OK. - Press or to select the [WLAN(Wi-Fi)] option, and then press OK.
- Press or to select the [Find Network] option, and then press OK.
- When [WLAN Enable?] appears, select On.This will start the wireless setup wizard.
- The machine will search for your network and display a list of available SSIDs. Press or to select the [<New SSID>] option, and then press OK.
- Enter the SSID name, and then press OK.
- Press or to select the Authentication Method you want, and then press OK.
- Do one of the following:
If you selected the [EAP-FAST], [PEAP] or [EAP-TTLS] option, press
or to select the Inner Authentication Method [NONE], [CHAP], [MS-CHAP], [MS-CHAPv2], [PAP] or [GTC], and then press OK. Depending on your Authentication Method, the Inner Authentication Method selections differ.Press
or to select the Encryption Type [TKIP+AES] or [AES], and then press OK. Press
or to select the Verification Method [No Verification], [CA] or [CA+Server ID], and then press OK. - If you selected the [CA+Server ID] option, enter the server ID, user ID and password (if required), and then press OK for each option.
- For other selections, enter the user ID and the Password, and then press OK for each option.
If you have not imported a CA certificate into your machine, the machine will display the message [No Verification].If you selected the [EAP-TLS] option, press
or to select the Encryption Type [TKIP+AES] or [AES], and then press OK. When the machine displays a list of available Client Certificates, select the certificate you want.
Press
or to select the Verification Method [No Verification], [CA] or [CA+Server ID], and then press OK. - If you selected the [CA+Server ID] option, enter the server ID and user ID, and then press OK for each option.
- For other selections, enter the user ID, and then press OK.
- To apply the settings, press. To cancel, press .
- The machine will attempt to connect to the wireless device you have selected.
You have completed the wireless network setup. To install the drivers or the application necessary for operating your machine, go to your model's Downloads page at support.brother.com/downloads.