Search

Set Sleep Mode Countdown

The Sleep Mode (or Power Save Mode) setting can reduce power consumption. Select how long the machine must be idle before it goes into Sleep Mode. The Sleep Mode timer is reset when the machine receives a print job.

When the machine is in Sleep Mode, it acts as if it is turned off. The machine will wake up and start printing when it receives a print job. Use these instructions to set a time delay (countdown) before the machine enters Sleep Mode.

image
The Sleep Mode setting cannot be disabled due to environmental considerations.

HL-L5210DN/HL-L5210DW/HL-L5215DN/HL-L6210DW

  1. Press image or image to select the following:
    1. Select [General Setup]. Press OK.
    2. Select [Ecology]. Press OK.
    3. Select [Sleep Time]. Press OK.
  2. Press image or image to enter the length of time (up to 50 minutes) that the machine should remain idle before entering Sleep Mode.
    Press Go.

HL-L6410DN/HL-L6415DN

  1. Press image[Settings]>[All Settings]>[General Setup]>[Ecology]>[Sleep Time].
  2. Enter the length of time (up to 50 minutes) that the machine should remain idle before entering Sleep Mode, and then press [OK].
  3. Press image.
Did you find the information you needed?